|
|
06-04-2013, 05:30 PM | #1 |
First, Welcome to the site.
You should enjoy the new scoot. Its a good bike. How familiar are you with the GY6 engine? Your problem is more than likely the valves. Readjust the IN. to .003 and the EX. to .004. Also, check to see if the plug wire is good. As for the gaskets, jet get some material from the nearest Auto Parts store, and cut your own. Cheapest, simplest way. Just don't forget the oil galley. lol What oils did you replace it with?
__________________
2007 Sportiva Falcon GY6 150 4T 7,200+ Mi. 68 ( GPS Verified ) 76 MPG Few Mods, Lots-O-Tweaks 2003 Vento Zip R3i TurboCam 50cc 2T 8,500+ Mi. 62mph ( GPS Verified ) 90 MPG Seriously Modded Check out the new group for the Mountain Area! http://www.scootdawg.net/group.php?groupid=4 |
|
06-05-2013, 07:39 PM | #2 |
Join Date: Jun 2013
Location: Minnesota
Posts: 73
|
Thanks for the reply!
I'm pretty much a noob when it comes to small engines. My first scoot, was a Geely 50cc so I did a LOT of learning! I don't mind though, I enjoy the learning and it takes my mind off of other things. Motor oil was 10w-30 synthetic and gear oil was 80w-90. To be honest, I've not run it much and after I get done with the crankcase gasket and the valves, I'll probably change it out again. |
|
|