Where is the Adjusting screw

judger · 07-06-2013, 03:48 PM

Greedtings All,How do you get to the carb adjusting screw for adjusting air/fuel mixture. Is it accessed from the top of the scoot or the bottom? I have all the outer plasic off the bike which is a 2011 Jonway yy250T. I would appreciate any assisstance you could give me.

smoak · 07-08-2013, 11:58 PM

Lots of different places, depends on the engine in it. A YY250T is the same as a MC54-250, but I am unsure if it has the yami clone or the honda clone. If thr bike has a horizontal motor, slip your finger under the carb right next to the intake manifold. Many of the yami (lifan) horizontal motors have the A/F screw dead bottom center of the outlet of the carb directly adjacent to the hard rubber intake manifold.

It could also be that your A/F screw has a brass cap straight from the factory that will have to be removed.

Hope this is helpful.

Smoak

07-08-2013, 11:58 PM	#2
smoak Join Date: Apr 2012 Location: Western KY Posts: 63	Lots of different places, depends on the engine in it. A YY250T is the same as a MC54-250, but I am unsure if it has the yami clone or the honda clone. If thr bike has a horizontal motor, slip your finger under the carb right next to the intake manifold. Many of the yami (lifan) horizontal motors have the A/F screw dead bottom center of the outlet of the carb directly adjacent to the hard rubber intake manifold. It could also be that your A/F screw has a brass cap straight from the factory that will have to be removed. Hope this is helpful. Smoak __________________
	0