24 spline wheel

guzzijohn · 09-11-2023, 03:40 PM

A little surfing found some interesting epoxy style fixes for splines on a “Heavy Equipment “ forum. I might red Loctite the nut as the manual says retighten @600 mile increments. But maybe not as my buddy who’s been in cycle repair 40 years says soft wheel metal creates loosening. He gave me an axle nut to replace the missing piece. Someone may have done a hack top end job as I found pieces of gasket in the oil screen. The oil was a quart over but if the same hack checked it on side stand that’s a possibility. It fired up on spray so I’ll clean carb and tank to try gas run. All the electrical works fine so just iron out any fuel issues like pump and petcock and order some GLUE!!??

09-11-2023, 03:40 PM	#2
guzzijohn Join Date: Sep 2023 Location: Champlin,Mn Posts: 5	A little surfing found some interesting epoxy style fixes for splines on a “Heavy Equipment “ forum. I might red Loctite the nut as the manual says retighten @600 mile increments. But maybe not as my buddy who’s been in cycle repair 40 years says soft wheel metal creates loosening. He gave me an axle nut to replace the missing piece. Someone may have done a hack top end job as I found pieces of gasket in the oil screen. The oil was a quart over but if the same hack checked it on side stand that’s a possibility. It fired up on spray so I’ll clean carb and tank to try gas run. All the electrical works fine so just iron out any fuel issues like pump and petcock and order some GLUE!!??
	0