|
|
|
|
|
01-25-2016, 06:11 PM
|
#1 |
 
Join Date: Oct 2008
Location: Hyde Park, NY
Posts: 1,068
|
Here we go again. Check vacuum lines. A engine that pulls well without load but dies when loaded is having a mixture problem. A cracked intake manifold or a vacuum line might be the problem. Spray WD-40 around the intake area and see if the idle changes or picks up.
__________________
2008 Eagle Milano 150- 9,679 miles 2009 Honda Rebel 250- 10,434 miles 2009 CF Moto Fashion- 16,023 miles 2009 MC-114 50cc Cub Clone- 4,317 miles twowheeler.yolasite.com/ That's 30,049 China Scootin miles and Counting. |
|
|
01-26-2016, 10:36 AM
|
#2 | |
 
Join Date: Jul 2013
Posts: 87
|
Quote:
I thing that the manifold is good, because i changed it, but i will try with WD. I will also try to change vacuum lines. Thanks again |
|
|
|
|
01-27-2016, 10:01 AM
|
#3 | |
|
Join Date: Jul 2013
Posts: 87
|
Quote:
Hello, i checked vacuum lines and intake manifold and everything seems to be OK. After that i dyscovered that there was 84 jet installed instead of 79. So I installed 79. Now scooter wants to die when i turn the throttle. Choke is working, i also put in new spark plug and its the same. Old spark plug was black. I also uploaded a video: Thanks. UPDATE: I founded out that the needle fall out of place, down on the jet. So i fixed that. It was a little bit better, but not much. Than i founded out that if i put electrical tape over inlet holls on airbox scooter goes almost good. Take off and mid-acceleration is good, but top end sucks. Something is wierd here haha. A replaced airbox, but nothing changed... Any suggestions? Thanks Last edited by padly1995; 01-27-2016 at 05:23 PM. |
|
|
|
 |
|
|
Hybrid Mode
