|
|
|
|
|
03-30-2017, 06:58 AM
|
#1 |
 
Join Date: May 2015
Location: Lanoka Harbor, NJ
Posts: 63
|
Pete,
When I first read this, I envisioned this split along the pipe, rather than at the seam; Reading again, I see that's what you had said. How does this muffler and pipe fit? What I'm asking is, does it seem to line up to all the mounts or do you have to torque it into place? Maybe there is stress on it when bolted in; then vibration causes it to crack at the weak point.?. This is the only picture I have of my muffler, but you can see where the strap attaches; it's underneath and further back, connected to posts on the swingarm. |
|
|
04-01-2017, 06:09 AM
|
#2 |
 
Join Date: Jul 2011
Location: Connecticut
Posts: 493
|
If you're using a muffler that attaches with straps, you have to place the strap as close to the middle as possible.
__________________
2011 Roketa MC-23-150 4T 150cc 157 qmj 24mm carb w 115 main jet and paper cone air filter Manual petcock w Tygon fuel lines Scrappy Dog Scooters Retro-slash stainless straight-thru exhaust RED spring clutch Adjustable CDI (brand unknown, it's blue and red and works great!) KOSO high performance variator w 12g sliders Gates Powerlink 835-20-30 belt GPS verified 65mph on flats. |
|
|
 |
|
|
Hybrid Mode
