Taotao Lancer & Powermax w/ a tall person

[feartheclown]

PDI nearly completed... Got it started today. Everything has been pretty smooth. Couple of issues we have run into...
Fuel filter replacement - Autozone couldn't find an exact match so ended up buying 1 that is slightly larger.
Plastic screw holes - In a couple of spots things are attached using a screw screwed entirely into a plastic fitting that we discovered was broken on arrival, 1 on the floor board and the other 1 on the side plastic fitting of the bike right above the taotao motors sticker in the above picture. Using some JB Weld to attempt to fix both, won't know how well it works til tomorrow after it dries.
Spark Plug - Mistakenly took the spark plug out without a magnetic socket, of course it got dropped. My buddy insisted he could get it out with his hand and knocked it back in the plastic housing on the side of the engine all the way to the back of the engine. Ended up having to take off the plastic housing on the side of it. Bought a magnetic socket when I got the new spark plug.
CVT Fill hole - The fill hole doesn't appear to have been properly created and there appears to be a thin layer of metal on it almost like a piece of skin giving it the appearance that its not actually a hole. Stuck a zip tie in there to determine if this was actually the fill hole which it was as the zip tie went straight through easily.
Hose Clamps - The hose clamps are by far the worst part of the assembly of the bike, way too many of them use these:

Luckily its an easy fix with zip ties.

Here's a vid of the scooter starting up: