Register FAQ Community Calendar Today's Posts Search
Go Back   ScootDawg Forums > Performance :: Maintenance :: Technical > 3-Wheeled Scooters
Reply
 
Thread Tools Search this Thread Display Modes
Old 02-09-2013, 10:43 PM   #1
Guest_2   Guest_2 is offline
 
Guest_2's Avatar
 
Join Date: Jul 2008
Posts: 79
2010 Magnum Update (Archive)

Update time with more pics.

This is the last of the magnum updates, the white gets to go to it's new home on Monday.

Installing the rear deck is a job that is best suited for 2 people, but it can be done carefully by yourself. As I mentioned before the key here is to assemble slowly and not tighten the bolts completely until all bolts and screws are attached. This leave "slack" for movement and alignment.



Left the rear of the trike with an appropriate jack and support it. I used a padded bike jack with a locking device. Remove the wheels.



Attach the rear brackets on each side, as close to the disc as possible. Remember not to tighten completely.



Top view of installed bracket.



Lift rear deck and install on brackets, install top screws, Be careful not to over torque.



This is the inside of the rear assembly showing the "slip" assembly.



Look to the left of the ID tag and you will see the bracket on the frame where the slip assembly goes. It just slides over this bracket. Now I went one step further and used a very heavy zip tie through the "slip" and around the bracket to hold it securely.

Now from underneath, tighten the brackets to the Axel. Make sure you alternately tighten each bolt, do not tighten one then the other.



Now that you are finished, you can take out the jack. I had to set the tires on 2x4s, then lower the jack. This gave room to get the pad jack out without damaging the rear deck.




Installed the radio under the seat in the helmet bucket. This was the strongest point to mount it. We used "L" brackets to the side of the radio, then drilled holes through the seat bucket area and bolted with lock washers and fender washers from underneath. The Radio antenna is located under the seat also. We found an antenna that is used in Harley fairings so there is not that ugly antenna on the outside of the bike.



Two 2 inch handle bar speakers were used. There really isn't an area on the trike that would support 6 inch rounds. Besides this directs the sound right at the rider. These speakers are full range, not just tweeters and sound really good.





Done and ready for delivery!




Login or Register to Remove Ads

Last edited by Guest_2; 11-01-2013 at 11:57 AM.
  Reply With Quote
Old 03-12-2013, 12:48 PM   #2
Swordsman   Swordsman is offline
 
Join Date: Mar 2013
Posts: 40
Good Lord, that thing's as big as a car!

~SM
  Reply With Quote
Old 03-16-2013, 12:45 AM   #3
scootnwinn   scootnwinn is offline
 
scootnwinn's Avatar
 
Join Date: Aug 2011
Location: Tierra Azul, NM
Posts: 739
How much rear suspension travel does it have?
__________________


Do not fear mistakes. You will know failure. Continue to reach out.
- Benjamin Franklin

Join the HARDCORE

1983 Honda GL650I SilverWing



Login or Register to Remove Ads
  Reply With Quote
Old 03-17-2013, 10:36 PM   #4
edfr   edfr is offline
 
edfr's Avatar
 
Join Date: Feb 2013
Posts: 4
The swingarm that carries the rear axle can move about 3 inchs.
Lefty
  Reply With Quote
Old 03-18-2013, 09:22 PM   #5
Guest_2   Guest_2 is offline
 
Guest_2's Avatar
 
Join Date: Jul 2008
Posts: 79
Keep in mind this is an archive post on a 2010. There has been a lot of mods since then.



Login or Register to Remove Ads
  Reply With Quote
Old 03-18-2013, 09:58 PM   #6
prodigit   prodigit is offline
 
Join Date: Jul 2012
Location: Miami, FL
Posts: 390
How's the radio?
I have a similar radio, Sony, but the screen is going on/off all the time...
__________________



  Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 07:06 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.