|
I'd try making sure the engine is topped off with motor oil but not overfull and run it through a few hot/cold cycles. It might get enough oil to get the little sprag rollers loosened up enough to work like it should. If the clutch starter is bad and has to be changed, watch a few youtubes on how to do it. It's not a hard job but it's one of those things you can learn a lot easier watching how others did it than learning the hard way, you'll know what tools you will need, and the nuts that are left hand thread.
Just type in starting clutch gy6 with youtube and you will see. Also sprag clutch just to see how they work, or are supposed to work.
|