Modifying Drive Face/"Gear"???
So, on my old Honda Metro, there was a mod that you could do to the Drive Face...
It required "spinning" the drive face on a type of lathe, and then "shaving" it down some, in order to get a higher top speed. You could also take the "lip" off of the center of the drive face and that helped top end as well.
Honestly, this was one of the BEST mods I did to my Honda Metro CHF50!
That said, I see that NCY sells an aftermarket one for our 50cc GY6 Chinese "Knockoffs". But I also don't see where it's ANY DIFFERENT from our stock ones? So what gives?
So, question is!!!! Is there a way to modify our drivefaces, without messing up the gear part for the starter???
Or am I going to have to be the Ginny Pig?!
__________________
Scooters are like sluts... you buy them, make em pretty, ride her for a while and then on to the next one!!! 
|