ScootDawg Forums - View Single Post

Cubby1331 · 04-07-2014, 10:07 PM

It should be easy if its any thing like a cars carb. Remember to tighten down all at same time. for example dont tighten one down completely before you thread the others. Hand tighten all screws then go in a diamond pattern to make sure its tighten down correctly. Also be careful not to strip the screws since i'm guessing the block is aluminum

04-07-2014, 10:07 PM	#8
Cubby1331 Join Date: Apr 2014 Location: Troy, Michigan Posts: 58	It should be easy if its any thing like a cars carb. Remember to tighten down all at same time. for example dont tighten one down completely before you thread the others. Hand tighten all screws then go in a diamond pattern to make sure its tighten down correctly. Also be careful not to strip the screws since i'm guessing the block is aluminum Last edited by Cubby1331; 04-09-2014 at 11:37 AM.
	0