View Single Post
Old 02-23-2017, 12:52 PM   #3
padly1995   padly1995 is offline
 
padly1995's Avatar
 
Join Date: Jul 2013
Posts: 87
Quote:
Originally Posted by wheelbender6 View Post
Float is stuck or set too high, possibly?
Hello,
Now I installed #98 main jet, idle jet is #50. I moved clip on needle on second notch from top to bottom, if I move it to top notch it starts cutting in midrange, if I move it lower, it starts to bogg more. It tooked bushing out of air filter, leaving just metal screen in there.
Now I can ride at flat, but still can`t climb hill. Take of is much better, it bogs to about 7k RPM.
I installed funnel made of metal screen in air filter and I noticed little change in low/mid RPM`S, but big change at high RPM`S, where it goes alot better. However in takes alot to get above 8k RPM in 4th gear and it`s cutting of a little in 1st gear sometimes...
Im going nuts with this moped.
Could this be too big idle jet?



Login or Register to Remove Ads
  Reply With Quote