it might, you just need to grease the needle bearing on the inside, also if this was the problem when you started the bike on the center stand the back tire would be spinning even at low rpms
__________________
2012 Jonway X
44mm Hoca crank
52mm Hoca big bore
MMS big valve head raised ports, polished, milled .023
Hoca 26mm carb
NCY titanium valve springs
NOS wet nitrous system
Holley fuel pump
MMS variator
Naraku CDI
HT coil
4' Wheelie bar
MMG stainless slip-on exhaust
NGK "11" spark plug
UNI filter
2014 Icebear Maddog
too much to list
http://mmsscooters.com
|