I didn't get a response in this thread:
http://www.scootdawg.net/showthread.php?t=52841 , so I'll post again here. I assembled this scooter and after the first two oil leaks rode it 250 miles on the china meter. Now the gasket where the two halfs of the crankcase come together is leaking. Looks as if the gasket is being squeazed out like playdoh:
On the backside of the motor, right in front of the rear wheel. I'm wondering what caused this? Too much crankcase pressure? Or the sealer I used during assembly to seal the gasket:
What does everbody use to seal their gaskets during assembly? Or do you just put them in dry? Any response would be helpful, thanks guys.