Go Back   ScootDawg Forums > Search Forums
Showing results 1 to 25 of 127
Search took 0.02 seconds.
Search: Posts Made By: skuttadawg
Forum: 125cc - 249cc 04-04-2014, 11:15 PM
Replies: 11
Views: 3,274
Posted By skuttadawg
You can clean the idle jet as it may need it to...

You can clean the idle jet as it may need it to be done or opt for a size larger IJ . Have the valves ever been adjusted ? Some need it to be done right out of the crate . All 4Ts will need it done...
Forum: 50cc - 124cc 04-04-2014, 11:09 PM
Replies: 38
Views: 13,917
Posted By skuttadawg
Sounds like to had the top off the carb off which...

Sounds like to had the top off the carb off which has the needle a diaphragm . The floats and jets are on the bottom inside of the bowl .

The CVT should have an air inlet tubing to allow air to...
Forum: General Scooter Discussion 04-04-2014, 11:02 PM
Replies: 5
Views: 1,826
Posted By skuttadawg
Then fan should turn off or on by the thermostat...

Then fan should turn off or on by the thermostat not the temp gauge . Get some Engine Ice or other coolant made for motorcycles rather than automotive type since small engines run at higher RPMs and...
Forum: 125cc - 249cc 04-04-2014, 10:59 PM
Replies: 8
Views: 2,739
Posted By skuttadawg
I was at my scooter dealers shop and he put on a...

I was at my scooter dealers shop and he put on a 63mm BBK without having to bore out the case like most need . I think he said it had ether the GY6 B or your engine as they have a thicker block he...
Forum: 50cc - 124cc 01-30-2014, 12:15 AM
Replies: 9
Views: 2,229
Posted By skuttadawg
Blue = 1k yellow 1.5k and red 2k . You may want...

Blue = 1k yellow 1.5k and red 2k . You may want to try a gram heavier in sliders . To truly have it a screamer you would want a 50mm BBK with a big valve head which would have better flow than the...
Forum: General Scooter Discussion 01-30-2014, 12:08 AM
Replies: 8
Views: 2,664
Posted By skuttadawg
Do you have SD decals ?

Do you have SD decals ?
Forum: 125cc - 249cc 01-30-2014, 12:07 AM
Replies: 10
Views: 2,577
Posted By skuttadawg
Be careful ! A buddy of mine got arrested for...

Be careful ! A buddy of mine got arrested for riding a 150 with a moped tag , no insurance , no license , tag or registration . He got a 1,200 dollar fine . I have saw where some peel off the 1 on...
Forum: 125cc - 249cc 01-30-2014, 12:00 AM
Replies: 8
Views: 2,221
Posted By skuttadawg
The 10 in wheels often display faster than they...

The 10 in wheels often display faster than they are going . My scoot with 13s was 4MPH off in 3 tests at diff speeds with a radar . My scoot with 16s was 1 MPH doing the same radar test . There was a...
Forum: 125cc - 249cc 01-29-2014, 11:54 PM
Replies: 4
Views: 4,093
Posted By skuttadawg
I would first check the airfilter and jets in the...

I would first check the airfilter and jets in the carb to see if they need cleaning . Popping from high RPMs is lean misfire which means your a lil lean . To fix that you simply replace the factory...
Forum: General Scooter Discussion 12-28-2013, 11:44 PM
Replies: 3
Views: 3,834
Posted By skuttadawg
Yes they come too lean . Many have the " secret...

Yes they come too lean . Many have the " secret 63cc " engine instead of a 49cc . Run it WOT until you hit top speed and hit the kill switch . Allow it to cool to avoid burning your fingers so you...
Forum: 125cc - 249cc 11-23-2013, 01:54 AM
Replies: 17
Views: 6,990
Posted By skuttadawg
Some you can go up 10mm wider if you have the...

Some you can go up 10mm wider if you have the clearances . Here is a visual calculator to compare two diff sizes with http://www.tacomaworld.com/forum/tirecalc.php

The 130/60/13 has plenty of tire...
Forum: 50cc - 124cc 11-23-2013, 01:34 AM
Replies: 3
Views: 1,571
Posted By skuttadawg
A 2T should smoke since it is burning oil along...

A 2T should smoke since it is burning oil along with gasoline . More so with cheap oil than synthetic . Mine smokes at start up when it is cold but it stops once the engine warms up . If it did not...
Forum: 125cc - 249cc 11-23-2013, 01:25 AM
Replies: 8
Views: 2,731
Posted By skuttadawg
I removed the lid off of the airbox on my 2T and...

I removed the lid off of the airbox on my 2T and 4T 50 for laughs . They both started up and were louder at idle but bogged so bad I did not leave the driveway . I would think you have a vacuum leak...
Forum: General Scooter Discussion 11-21-2013, 12:04 AM
Replies: 3
Views: 1,429
Posted By skuttadawg
http://www.scooterparts4less.com/ALL_Rims.htm

http://www.scooterparts4less.com/ALL_Rims.htm
Forum: 50cc - 124cc 11-20-2013, 11:39 PM
Replies: 5
Views: 1,676
Posted By skuttadawg
Sounds like the valves need adjusting as they may...

Sounds like the valves need adjusting as they may not be opening up enough . All 4T engines will need to have it dome at least once . When it warms up does it stall ? When they are too tight it will...
Forum: 125cc - 249cc 11-20-2013, 11:34 PM
Replies: 6
Views: 2,728
Posted By skuttadawg
Without the exhaust and not upjettint to...

Without the exhaust and not upjettint to compensate the additional airflow it will be too lean , run hot and will damage your engine in a short time . A buddy who drinks too much wrecked his scoot...
Forum: 50cc - 124cc 11-20-2013, 11:25 PM
Replies: 5
Views: 1,917
Posted By skuttadawg
If it blew the fuse you may have a bad voltage...

If it blew the fuse you may have a bad voltage regulator also called rectifier . NEVER by pass a fuse except when troubleshooting . A fuse it much cheaper than replacing fried parts . Did you use...
Forum: 50cc - 124cc 11-20-2013, 11:18 PM
Replies: 9
Views: 2,485
Posted By skuttadawg
I have heard of modding larger size rollers which...

I have heard of modding larger size rollers which I am told can put the belt out more but I have not tried to do it . I use Dr Pulley sliders in both of my scooters instead of rollers and I must say...
Forum: 50cc - 124cc 11-20-2013, 11:11 PM
Replies: 7
Views: 6,176
Posted By skuttadawg
I have heard of some using a sip of 2T oil for a...

I have heard of some using a sip of 2T oil for a 4T with bad rings .

Marvel Mystery has been around since the 20s or so . My auto repair instructor taught us about using it . Yes it will smoke if...
Forum: 50cc - 124cc 11-20-2013, 10:58 PM
Replies: 5
Views: 2,079
Posted By skuttadawg
Yes unbalanced it will wobble . I had ,y dealer...

Yes unbalanced it will wobble . I had ,y dealer balance mine and on the CS it does not wiggle any more than 1/4 of a mm . He used this...
Forum: 50cc - 124cc 11-14-2013, 12:17 AM
Replies: 12
Views: 9,288
Posted By skuttadawg
Are you running that Uni dry ? It needs to be...

Are you running that Uni dry ? It needs to be oiled or it be too lean . Sometimes with the stiffer clutch springs you need heavier weights to push out the belt .

It looked like the RPMs got...
Forum: 125cc - 249cc 11-13-2013, 11:41 PM
Replies: 5
Views: 3,350
Posted By skuttadawg
Look on the left column for 157QMJ ...

Look on the left column for 157QMJ http://www.scrappydogscooters.com/Home_Page.php
Forum: 50cc - 124cc 11-13-2013, 11:34 PM
Replies: 3
Views: 2,464
Posted By skuttadawg
Your best bet would be to get a jet kit instead...

Your best bet would be to get a jet kit instead paying per jet prices . Here is a jet kit http://www.partsforscooters.com/114-49-QMB139-Main-Jet-Kit?sc=34&category=133078

Most have the fuel/air...
Forum: 50cc - 124cc 11-13-2013, 11:27 PM
Replies: 9
Views: 2,485
Posted By skuttadawg
Interesting as most Minarellis use 15x12 weights...

Interesting as most Minarellis use 15x12 weights . Does it have a 90cc variator or an aftermarket one ?
Forum: General Scooter Discussion 11-09-2013, 01:22 AM
Replies: 40
Views: 20,799
Posted By skuttadawg
After being spoiled by April a TaoTao will not...

After being spoiled by April a TaoTao will not come close in comparison . I had a TaoTao ATma " secret 63 " and it did perform better than most 50s with only lighter rollers (8g to 5g ) and a larger...
Showing results 1 to 25 of 127

 
Forum Jump

All times are GMT -4. The time now is 12:41 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.