Register FAQ Community Calendar Today's Posts Search
Go Back   ScootDawg Forums > Search Forums
Reload this Page Search Results
Showing results 1 to 23 of 23
Search took 0.01 seconds. Search: Posts Made By: jmstar09
Forum: 125cc - 249cc 04-25-2013, 10:59 PM
Replies: 11
Views: 15,686
Posted By jmstar09
Belt flop is a fact of life. It doesn't matter...

Belt flop is a fact of life. It doesn't matter what brand you use, it's gonna happen. Think about a stretchy rubber belt getting pulled on and then compressed when engine RPM's vary slightly. The...
Forum: Wanted 04-25-2013, 04:23 PM
Replies: 2
Views: 6,360
Posted By jmstar09
Yes I did.

Yes I did.
Forum: 125cc - 249cc 04-20-2013, 01:14 PM
Replies: 11
Views: 15,686
Posted By jmstar09
Remove the belt and variator and run it. If the...

Remove the belt and variator and run it. If the noise persists then it's not related to the belt/CVT. If the noise goes away, then I would start looking at the clutch. It has two bearings.
...
Forum: 125cc - 249cc 04-19-2013, 04:22 PM
Replies: 4
Views: 4,536
Posted By jmstar09
stator went bad on you due to the loose...

stator went bad on you due to the loose connections. maybe fried the reg too.
Forum: 125cc - 249cc 04-19-2013, 04:18 PM
Replies: 19
Views: 12,066
Posted By jmstar09
I have had to fix at least ten of those over the...

I have had to fix at least ten of those over the years and what I do is to pick out all the old plastic "Glass" and then clean the entire window with brake cleaner to remove any trace of brake fluid...
Forum: 125cc - 249cc 04-19-2013, 04:05 PM
Replies: 6
Views: 4,871
Posted By jmstar09
On the Milan the switches are like this one. The...

On the Milan the switches are like this one. The right and left switches are made opposite each other so you have to order one of each. Also, don't over-tighten the screws that hold the switch in...
Forum: 50cc - 124cc 04-19-2013, 04:00 PM
Replies: 6
Views: 6,616
Posted By jmstar09
Remove the variator and grab the crank with your...

Remove the variator and grab the crank with your hand and try to move it side to side. If the bearing is sloppy then there's your problem! If the bearing is failing, it'll eventually make a clunking...
Forum: 50cc - 124cc 04-19-2013, 03:57 PM
Replies: 5
Views: 5,629
Posted By jmstar09
Sounds like the cam bearings are shot maybe....

Sounds like the cam bearings are shot maybe. Remove the cam and see if the bearing have any slop in them.
Forum: Wanted 04-19-2013, 03:54 PM
Replies: 2
Views: 6,360
Posted By jmstar09
WANTED! Front Left Blinker Lens 150cc

Need the left side lens down on the body (rear brake lever side) for this type:

http://store.oohla.com/storefiles/terminatorscooter//upload/imagemanager/998/1211157142743.jpg
Forum: 50cc - 124cc 02-03-2013, 01:45 AM
Replies: 2
Views: 3,027
Posted By jmstar09
Contra Spring for Bone Stock minarelli

I have an un-modded 49.7 cc minarelli scooter that runs great. 4.5 gram rollers, stock variator and a fairly new Gates 788 belt. It goes 40-45 on flats no problem but the initial take-off is lacking...
Forum: 125cc - 249cc 01-31-2013, 03:41 AM
Replies: 29
Views: 14,939
Posted By jmstar09
How about we all just check the nuts once in a...

How about we all just check the nuts once in a while? I have an '03 scooter with close to 9000 on it and the exhaust has never leaked because every 2-3 weeks I go over it and check/tighten any...
Forum: General Scooter Discussion 01-28-2013, 09:33 PM
Replies: 37
Views: 20,824
Posted By jmstar09
That's really not a scooter but a full on road...

That's really not a scooter but a full on road bike something like this:

http://www.dieselstation.com/img/Yamaha/2009-FJR1300AE/2009-Yamaha-FJR1300AE-04.jpg
Forum: 50cc - 124cc 01-28-2013, 09:14 PM
Replies: 12
Views: 7,519
Posted By jmstar09
Dont take chances with the throttle cable....

Dont take chances with the throttle cable. Replace it! I tried lubing a sticky cable once and I ended up in the hospital cause it got stuck at WOT doing 35 MPH I had to dump the scooter because I was...
Forum: General Scooter Discussion 01-28-2013, 09:08 PM
Replies: 37
Views: 20,824
Posted By jmstar09
I have to admit I laughed pretty hard when I saw...

I have to admit I laughed pretty hard when I saw it the first time but that really sucks for the guy cause his scooter has gotta be pretty much totaled. :no:
Forum: 125cc - 249cc 01-27-2013, 09:13 PM
Replies: 29
Views: 14,939
Posted By jmstar09
I've never had an issue using the standard nuts...

I've never had an issue using the standard nuts with split washers.
Forum: Forum News, Support & Feedback 01-27-2013, 08:01 PM
Replies: 8
Views: 6,207
Posted By jmstar09
Oh you like that huh terilee?

Oh you like that huh terilee?
Forum: Forum News, Support & Feedback 01-27-2013, 07:57 PM
Replies: 8
Views: 6,207
Posted By jmstar09
So it was me that needed to get on the ball....

So it was me that needed to get on the ball. :ugh:

Thanks!
Forum: Forum News, Support & Feedback 01-27-2013, 07:36 PM
Replies: 8
Views: 6,207
Posted By jmstar09
They don't show up for me... I have an Imac I use...

They don't show up for me... I have an Imac I use Firefox with OSX 10.4.11 (older version).
Forum: 125cc - 249cc 01-27-2013, 07:27 PM
Replies: 29
Views: 14,939
Posted By jmstar09
I ordered a few of these sets a while back to...

I ordered a few of these sets a while back to have on hand.
...
Forum: 125cc - 249cc 01-27-2013, 07:16 PM
Replies: 19
Views: 24,622
Posted By jmstar09
Sometimes a carb is beyond cleaning/repairing. I...

Sometimes a carb is beyond cleaning/repairing. I have had scooters come in that had sat for a while that didn't want to run correctly. Cleaned the carb 2 or 3 times with no change so finally I...
Forum: Forum News, Support & Feedback 01-27-2013, 07:10 PM
Replies: 8
Views: 6,207
Posted By jmstar09
Someone needs to get on the ball!

We need the buttons that control pic insertion, font, etc...
Forum: 50cc - 124cc 01-27-2013, 06:06 PM
Replies: 10
Views: 8,576
Posted By jmstar09
Next time connect the fuel line to the carb and...

Next time connect the fuel line to the carb and suck on the vacuum line for 15-20 seconds to fill the bowl and you'll save the battery and the starter.
Forum: The Dawg Pound 01-24-2013, 10:43 PM
Replies: 30
Views: 14,300
Posted By jmstar09
I don't like change when it comes to web forums...

I don't like change when it comes to web forums but after a while we will all get used to it. Fancy fonts and colors can still be done. I'm wondering where the youtube and the photo buttons are.
Showing results 1 to 23 of 23

 
Forum Jump

All times are GMT -4. The time now is 01:53 PM.

Contact Us - ScootDawg.net - Archive - Top
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.