gy6 50cc no power...
Hello, im repairing Jonway gy6 scooter for some guy.
First it was stuttering and i founded out that there was white plastic circle part that goes over the needle missing in the carburator. I installed new one and scooter has stopped stuttering. But it still doesnt have any power. It goes around 20 - 30kph, it has realy bad acceleration and it goes on realy low rpm. If I put scooter on the center stand, so wheel is up, it revs normaly, however if i press brake it instantly loses power. I tried to play with air intake, but there is no difference. I checked valve cleareces and they are both OK. Also the camshaft is lined up as it should. I can also hear some strange noise comming from under the flywheel I think. What do you suggest me to do? Do you thing this could be CVT problem? Thanks |
Here we go again. Check vacuum lines. A engine that pulls well without load but dies when loaded is having a mixture problem. A cracked intake manifold or a vacuum line might be the problem. Spray WD-40 around the intake area and see if the idle changes or picks up.
|
Quote:
I thing that the manifold is good, because i changed it, but i will try with WD. I will also try to change vacuum lines. Thanks again |
Quote:
Hello, i checked vacuum lines and intake manifold and everything seems to be OK. After that i dyscovered that there was 84 jet installed instead of 79. So I installed 79. Now scooter wants to die when i turn the throttle. Choke is working, i also put in new spark plug and its the same. Old spark plug was black. I also uploaded a video: https://youtu.be/JYDYN4kvKPk Thanks. UPDATE: I founded out that the needle fall out of place, down on the jet. So i fixed that. It was a little bit better, but not much. Than i founded out that if i put electrical tape over inlet holls on airbox scooter goes almost good. Take off and mid-acceleration is good, but top end sucks. Something is wierd here haha. A replaced airbox, but nothing changed... Any suggestions? Thanks |
check the compression and exhaust pipe gasket @ the head
|
Quote:
|
All times are GMT -4. The time now is 03:45 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.