low beams tail light and auto choke don't work
 

i have a 2014 wolf rx 50. this morning i turned it on and 1 second after it started the low beams, side lights and tail lights went out. i also noticed the auto choke did not shut off after warming up. i flipped the switch for the high/low beams to turn on the high beams and when i did the high beams, side lights and tail light came on. also the auto choke shut off. so i had to ride to school at 530 this morning with the high beams on. when i got home i checked all voltages and they were good at all wires one connectors and they all have continuity. but still only the high beams work. i also noticed when i had the 9 pin plug unplugged by the buttons on the handle bar the side lights would come on but not the head lights. any ideas? i need to fix this asap as this is my only ride to school. thanks!

Check the fuses and that connector to make sure there is no pins pushed out.

Check your main fuse wire (primary circuit).

Also check ALL frame grounds.

I'm with Blueboy it sounds like a fuse or a ground. In all of the ones I've messed with a faulty ground was the cause.

it turned out to be a short to ground inside the lightbulb (headlight). i never gave that any thought because i saw the filament was good. that caused all voltage to short to ground. thanks for the help though

Off topic, but I always ride with my high beams on.

Hell. You should ALWAYS RIDE WITH HIGH BEAM ON. Its safer and you can see those peskY 'POT' holes. Safe scootin to all