PDA

View Full Version : It dies.


hobbles
07-28-2016, 08:42 AM
Morning Boys,
I have a problem with my GY6 150 running.
I set the valves, got a new carb, new manifold gaskets and adjusted the carb. But if I give it any throttle it dies as you can see. What am I missing????

Click HERE (http://vidmg.photobucket.com/albums/v323/hobbles/Judy/Trike/trike%20temp/7-27.mp4) to watch.

rks
07-28-2016, 05:36 PM
After watching your video, I'd have to say your problem is electrical, not fuel related. The reason I say this is that it shuts down as if you hit the kill switch. (In reallity that is probably what you are doing) Think I might start with the right grip.....check kill switch, it's wiring, and clearance with moving throttle pieces housed in the grip.

hobbles
07-28-2016, 07:17 PM
Afternoon rks. (http://www.scootdawg.net/member.php?u=24461)

It would be nice if it was that simple. I can give it throttle slowly and it won't die. It's only when I do it fast. I can ride it down the road ok, I just can't rev it up or take off fast. I used a water hose and checked for air leaks, I flooded it! It only stops when the water hits the spark plug. No vac leaks,,,, that I found.

Impaired
07-29-2016, 10:51 PM
These are just a few ideas,
Could it be possible that when you accelerate too quickly you flood the carburetor? Maybe you need to upjet?
How's your air filter look? Maybe you aren't getting enough air to support the rush of gas from a quick accelaration? (If moped even work this way, I'm still learning these machines myself.)

Maybe you could have a problem in your clutch springs?

Again these are just ideas I'm no expert.

hobbles
07-30-2016, 11:15 AM
It runs good going down the road, good pickup. It might be a jet needs changing.
Ahh heck, it runs good, I think I will just leave it alone and ride it.

Irish
07-30-2016, 12:12 PM
It's hard to diagnose something without working on it yourself but it sounds very much as if you're running to lean! Irish

kz1000st
08-02-2016, 03:55 PM
So it runs good unless you yank the throttle wide open?

A man goes into see his doctor and tells him; every time I swing my arm over my head it hurts. The doctor says, "Don't do it then"

stitch_man87
08-03-2016, 11:56 PM
Try changing your coil. I had a similar issue and that's what caused mine... also they're stupid cheap

hobbles
08-05-2016, 07:01 AM
Mornin stitch_man87 (http://www.scootdawg.net/member.php?u=25697),
I'm thinking the same way. I ordered one yesterday.
http://www.ebay.com/itm/151750002895?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT

epyon96r
08-05-2016, 01:25 PM
Hi, I'm not too knowledgeable on jetting, but did you adjust both the pilot and main jet? If it its dying at wot you might need more carb tuning?

stitch_man87
08-05-2016, 03:05 PM
Hi, I'm not too knowledgeable on jetting, but did you adjust both the pilot and main jet? If it its dying at wot you might need more carb tuning?

the pilot is more for idling adjustment, try out some different main jets

epyon96r
08-07-2016, 01:05 PM
the pilot is more for idling adjustment, try out some different main jets
Yes the pilot the is more for idle. I know he stated he adjusted the carb. I was just wondering what he adjusted. :scoot:

stitch_man87
08-07-2016, 07:34 PM
It'd have to be the pilot, it's the only adjustable thing on a regular gy6 carb

stitch_man87
08-07-2016, 07:35 PM
Excluding idler screw*

Mäwby
08-08-2016, 08:46 AM
Could be that the main jet is too large in the carb. I had that issue.

epyon96r
08-08-2016, 04:07 PM
It'd have to be the pilot, it's the only adjustable thing on a regular gy6 carb

Ahh ok, you are right. Its been a while. I recently got a used scoot this weekend and am actually experiencing this same issue as well. My thought is the main jet is partially clogged and opening the throttle is killing it?

Also to add another thought. maybe its the diaphram in the carb not coming up(pulling up the main jet needle). Scooters can be difficult to diagnose sometimes.

hobbles
08-10-2016, 05:45 AM
Mornin Boys,
Parts came and I installed them, then took the Wife into town for ice cream at the dairy queen for a test ride. All fixed, runs good again. Not bad for $17.

http://img.photobucket.com/albums/v323/hobbles/Judy/Trike/ready%20to%20go.jpg

stitch_man87
08-10-2016, 07:31 PM
Glad to hear it! You anywhere near Somerset? I'm taking my scooter down to the cruise on the 27th and I wanna see more scooters out there lol

hobbles
08-11-2016, 09:46 AM
Mornin stitch_man87 (http://www.scootdawg.net/member.php?u=25697) .
Sorry, but Somerset is 103.3 miles from me and that's using the main highways, which are two lanes. We'd get run over before we got there. We use the back roads to get to Scottsville or Bowling Green.