jeffwheels62
03-03-2013, 11:28 AM
I recently purchased an Eaton Beamer scooter.
It had been sitting,a while,when I got it.
At firdt,it had a strange habit of starting right up,but dying after a secon,or two.
So I did the usual fuel system replacement.
New lines and filter,cleaned the tank and replaced fuel valve.
I also did a carb rebuild.
I dissasembled the top end and inspected...all good.
I reassembled it and YEEHAW! She ran like a champ!
Great throttle response,good power and close to 50mph top speed.
Then,yeaterday,she wouldnt start.
After some investigation,I found there was NO spark.
Ive checked every component,except the stator.
Any advice?
It had been sitting,a while,when I got it.
At firdt,it had a strange habit of starting right up,but dying after a secon,or two.
So I did the usual fuel system replacement.
New lines and filter,cleaned the tank and replaced fuel valve.
I also did a carb rebuild.
I dissasembled the top end and inspected...all good.
I reassembled it and YEEHAW! She ran like a champ!
Great throttle response,good power and close to 50mph top speed.
Then,yeaterday,she wouldnt start.
After some investigation,I found there was NO spark.
Ive checked every component,except the stator.
Any advice?